Free forum : Zenthusiast.net

Hey guys, I was wondering if anyone knows a good repair shop for Z32's near Newark. I just got mine a few weeks ago and i've encountered some trouble and wanna make sure the car's ok. Thanks sooooo much!

Its a 1992 300ZX N/A, 2DR.

Well..Two days ago i cleaned the K&N Air filters, and changed all plugs, since then the car doesn't wanna keep a steady idle, miss fires more then it did, doesn't feel like its putting out the power it should be putting out when pressing the gas while driving, and sometimes while driving the car just dies out, and i gotta turn the key or put it in gear...

[ Full reading ]

Finally decided to go HID so got the DDM 55W/6000K kit. Already put a DDM kit in my wife's Odyssey and it went really smooth.

Not on the Z, unfortunately, so need some help.

The DDM kit for lo beams looks pretty straightforward until you look at the bulb harness (on the left in pic below). The bulb is the correct socket type (9006), but it appears to have an extra wire r...

[ Full reading ]

Well as many of you on this forum may know that Ive been having problems with my car such as miss firing, high idle, idle jumping, sometimes just dying out, and the gas in the oil pan situation.

Today i figured it was nice enough to go out and learn something new, so i figured id make an effort and run self diagnostics on my ECU.

The ECU gave me a code of Long Flash, ...

[ Full reading ]

so when i bought my Z the only upgrades were a wing, rims and audio. not even a KN filter! sweet!

anyway.. im still pimping around this monsterous universal wedge box housing 3 10" MTX subs.

im long past the 'down the street booming' and have since bought a Q logic cylinder shaped home for a Rockford 10". It sits pretty nice tucked into the corner of the 2+...

[ Full reading ]

which shocks have a better ride quality with lowering springs? i installed some ground control coilover springs and my oem struts are a bit squeaky after the drop. i'm looking for opinions from those who have purchased either of these shocks. thanks guys and gals Very Happy

i'm pretty pleased with the results,hell of alot easier than the old fashion way.

[ Full reading ]

sorry it took me so long to get this up for everyone in a much more manigable thread. Hopefully tomorrow ill finish the rebuild and have some more pics to go along with it. enjoy Smile

Eagle rods and ARP rod bolts torqued to 43 ft lbs w/ ARP lube

Me prepping my oil pan for insta...

[ Full reading ]

Since I lost one injector, I'm anticipating that the others will begin to fall one by one.

I'd rather just put new injectors in (vs. used) though might consider "slightly" used.

Question is... For NA, any reason to go with 555's or just stick w. 370's?

Steve